Airsoft Canada - View Single Post

RUSTSPOT · January 10th, 2012, 06:19

just got this today from ASG.

over all , the material of the body is very decent. seems to be a machined pot metal. but still pretty damn well put together for airsoft standards.

i like the hop up and how the gun could easily be taken apart . one pin and the entire upper slide forward and out of the lower receiver.

one of the best trades ive seen in an AS

magpul trigger guard install.

trigger guard is not AS M4 standards, i have to trim a mil off of each side. but from measuring, the trigger guard should fit a real steel unit perfectly.

troy battle sights on . but these are the M4 standard heights. i need to get some low pros. thinking troy micros....

i dont have the privilege to post on the show case sub forum or i wouldve post this there. maybe we could make this THE XCR thread. i pulled a search and i dont think there is one.

January 10th, 2012, 06:19	#1
RUSTSPOT Sgt. Sparkles Trader rating Join Date: Nov 2008	VFC Robinson Armament XCR just got this today from ASG. over all , the material of the body is very decent. seems to be a machined pot metal. but still pretty damn well put together for airsoft standards. i like the hop up and how the gun could easily be taken apart . one pin and the entire upper slide forward and out of the lower receiver. one of the best trades ive seen in an AS magpul trigger guard install. trigger guard is not AS M4 standards, i have to trim a mil off of each side. but from measuring, the trigger guard should fit a real steel unit perfectly. troy battle sights on . but these are the M4 standard heights. i need to get some low pros. thinking troy micros.... i dont have the privilege to post on the show case sub forum or i wouldve post this there. maybe we could make this THE XCR thread. i pulled a search and i dont think there is one.