|
no i know but if i use i higher tourque engin i can get away with a higher powerd spring. i want to bring my gun to 400fps in the end. i plan on geting a bore up cylender kit from systema and perhaps a 120pdi spring. but i want to know if a 6.03mm barel is to tight, as in will i have problems with bb's jaming n such. i would also like a slightly longer barrel. i plan to conseal it under a silencer. i would rather optimize my gun for maximum eficiency to get a higher FpS rather than just over powering it. sure i can trow in the highest touque engine available. but if i can avoid it. then whats the point. its just that i would have thoes 2 engins availible to me is all.
in the bitter end i want 400fps with a 0.20g bb with the tightest groupings posible at 40 yards. i dont know what the fps on a 0.25g bb would be though. i am not overly concerend with RoF
|