Quote:
Originally Posted by ILLusion
Did you check the copper contacts at the trigger? Sometimes, if the gearbox isn't shimmed right or if the spring is too heavy, it can cause severe arcing across the contacts, which can ultimately burn holes through them. This again, will result in a bottleneck in the circuit.
|
i went to an op-for game to switch out a loaner motor,,,and then it started popping fuses. at that point i realized that it was beyond my capabilities to repair and i left it in the hands of a gun tech. apparently "jasper" from op-for says it was my selector plate not dropping into the right place because of worn shims that was causing the draw. the shims werent to bad,,but enough to cause the "bottleneck". i will be testing/picking up the rifle on saturday the 14th. if all is well i will get a better description on what "jasper" did to fix my rifle and post that up in the aeg solutions section for anyone else who may have this problem along the way. for now im calling this problem solved and would like to thank everyone for the time and ideas.